Hey thanks for putting this post up. Here are the answers
The M.2 area can support 2242 and maximum 3042 form factors. 2230 can fit inside but there is no separate screw to hold on 2230 modules, but extenders are available
Our hardware design allows the DisplayPort over Type-C to scale to 4K, because we are using two 4-lane LVDS as an input to our LVDS to DP controller. As per processor reference, via odd-even pixels this can give us combined bandwidth that can drive 4k30. On practical side, we havent been able to get 4k30 working on the evaluation kits due to multitude of reasons, but we got 1080p60 working. So we are waiting to test this properly on the Comet’s IMX95 board that are yet to arrive in two weeks from now.
The LTE modem is installed via M.2 that you can bring on your own, or you can get the modem+antenna pre-assembled from us or buy the modem+antenna kit from us latter. We just got everything cleared off in this week from antenna design, regulatory and carrier support point-of-view. The modem will be available as an addon latest by next week on the Mecha Hub (hub.mecha.so)
Hello,
I am waiting for the release of an AZERTY keyboard to order a Mecha Comet
While waiting for it to come out, I’m doing some research, and I’d like to ask a few more questions here:
Dual boot is possible, our standard flow uses UEFI images, you can have multiple entries in the boot partition. Also you can have separate boot from emmc and SD card, and select during boot time.
May I ask a question : in the update of your blog, there are a lot of mentions of the LTE modem
You refer to carriers’ compatibility for EU without distinction, I hope the european carriers have uniformized standard
Besides, have you evaluated the Specific Absorption Rate (SAR) for the LTE upgrade kit pre-assembled with modem (Quectel EM060K-GL, voice enabled) ?
Thanks again and congratulations on your progress !!